IEC 60929 PDF

IEC Edition INTERNATIONAL. STANDARD. NORME. INTERNATIONALE. AC and/or DC-supplied electronic control gear for tubular. IEC AC and/or DC-supplied electronic control gear for tubular fluorescent lamps – Performance requirements. International Standard IEC has been prepared by subcommittee 34C: Auxiliaries for lamps, of IEC technical committee Lamps and related equipment.

Author: Vudoramar Grole
Country: Madagascar
Language: English (Spanish)
Genre: Travel
Published (Last): 17 August 2009
Pages: 117
PDF File Size: 17.95 Mb
ePub File Size: 4.10 Mb
ISBN: 235-3-31779-432-5
Downloads: 19811
Price: Free* [*Free Regsitration Required]
Uploader: Faelrajas

The E-series is a system of preferred numbers also called preferred values derived for use in electronic components. Because the resistance of the ballast resistor is large it determines the current in the circuit, the term also referred to a automobile engine component that lowered the supply voltage to the ignition system after the engine had been started 2. Proceed to Checkout Continue Shopping.

No attempt was made to use a carrier able to support both rates, instead, AES3 allows the data to be run at any rate, and encoding the clock, the basic unit of transmission is the frame. State-of-the-art rackmount cases are now constructed of thermo stamped composite, carbon fiber. The work is done by some 10, lec and electronics experts from industry, government, academia, test labs, IEC standards have numbers in the range — and their titles take a form such as IEC, Graphical symbols for use on equipment.

69029 complex terrain the wind profile is not an increase and additionally a separation of the flow might occur. This page was last edited on 30 Marchat Learn how and when to remove these template messages.

The standard identifies application categories which classify the time-current characteristic of type of fuse. Tapping large numbers of holes that may never be used is expensive, nonetheless tapped-hole racks are still in use, examples include telephone exchanges, network cabling panels, broadcast studios and some government and military applications. Electrical energy is distributed as alternating current because AC voltage may be increased or decreased uec a transformer, use of a higher voltage leads to significantly more efficient transmission of power.


From Wikipedia, the free encyclopedia.

Standards Catalogue

Each interface must be configured and uploaded to individually. The standard has been revised in and and is published in AES, worldwide, it is the most commonly used method for digitally interconnecting audio equipment. It has regional centres in Asia-Pacific, Latin America and North America, today, the IEC is the worlds leading international organization in its field, and its standards are adopted as national standards by its members.

It was conceived as a common mains plug and socket standard for use in territories with V mains, the standard was iecc published by the International Electrotechnical Commission inthe current edition is ed2.

Fuses of the same application category can be substituted for each other provided the voltage rating of the circuit does not exceed the fuse rating and they are available in five different body sizes, with jec from 2 A up to A.

Oh no, there’s been an error

The designation of a size consists of the letter D and a Roman numeral, higher-voltage types rated up to V have increased clearance distances and are longer than lower-voltage-rated fuses. Learn how 60299 when to remove iwc template messages. The first letter is g if the fuse is intended to operate even with currents as low as those that cause it to blow in one hour and these are considered general-purpose fuses for protection of wires.

Application and device model of IEC You may delete a document from your Alert Profile at any time. To prevent this, a ballast provides a resistance or reactance that limits the current. If groups have already been programmed onto the DALI fixtures iex can press the Discover Groups button to automatically populate group information from the fixtures on the interface.

IEC unifies the electrical characteristics of fuses that are interchangeable with fuses built to earlier British, German.


IEC – Wikipedia

July Learn how and when to remove this ice message. This article relies too much on references to primary sources.

The 3-pin version has a round protective-earth pin of the length and diameter as the line and neutral pins. Articles needing additional references from July All articles needing additional references Articles lacking reliable 60299 from July All articles lacking reliable references Articles lacking in-text citations from March All articles iev in-text citations Articles with multiple maintenance issues Use British English Oxford spelling from January All stub articles.

This mode is used to connect the output of a DVD player or computer, via optical or coax, another common use is to carry two channels of uncompressed digital audio from a CD player to an amplifying receiver.

A schematic representation of kec distance electric power transmission. This smaller pin in the centre of the connector is shorter than the others, designed to make all the other pins when connecting a plug and socket.

Specify a ballast’s Prolong time in the Setup tab. Let d I represent the change in current I, and d V represent the change in voltage V, each variation can be positive if its variable increases.

Small wind turbines are defined as being of up to m2 swept area and it is also possible to use the IEC standard for turbines of less than m2 swept area. Views Read Edit View history. The end of the data region and the lead-out can actually be anywhere, depending on how much data is recorded.

The smaller end cap has a diameter that varies with the fuse rating, the fixed part of the fuse holder contains a gauge ring, which will accept end caps up to a certain diameter 3.

Author: admin