Test Method. All fittings were assembled in accordance with Parker’s published instruction. All tests were performed in accordance with ASTM F Annex A1. The Details refer to the ANNEX of ASTM F Test. Report (FITOK-FTR- ,Total 55 pages)-Part of A4 Hydrostatic Proof Test. Test Methods: All fittings were assembled in accordance with SSP published instructions. All tests were performed in accordance with ASTM F.
|Published (Last):||14 March 2008|
|PDF File Size:||20.53 Mb|
|ePub File Size:||2.12 Mb|
|Price:||Free* [*Free Regsitration Required]|
Historical Version s – view previous versions of standard. Work Item s – proposed revisions of this standard. This specification establishes the performance characteristics required for mechanically attached fittings MAFs for use in piping and tubing systems. These fittings directly attach to pipe or tube by mechanical deformation of the pipe or tube or fitting, or a combination thereof, creating a seal and a restrained joint.
ASTM F1387 Tube Fitting Performance Standards
MAFs covered here are classified into the following design types: Moreover, the Aatm shall be made from on or more of the following material grade: The MAFs shall also be zstm into ten classes according to their pressure ratings.
The standard qualification tests to which the MAFs shall perform satisfactorily are pneumatic proof test, hydrostatic proof test, impulse test, flexure fatigue test, tensile test, hydrostatic burst test, repeated assembly test, rotary flexure test, and mercurous nitrate test.
Successful completion of the tests described constitutes completion of the technical portion of the qualification. This abstract is a brief summary of the referenced standard.
CBC-Lok ASTM F Certification | tylok
It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. The seal may be created via the mechanical deformation or created independently. Successful completion of the tests described constitutes completion of the technical portion of the qualification process.
These shall apply only when specified in part or whole by the purchaser in the order. Unless otherwise specified, U. Navy contracts shall invoke the supplementary requirements in whole.
These tests are not intended for use in the evaluation of non-MAF products. This test provides general guidelines to determine the responsiveness of MAFs when subjected to fire.
This test should not be considered for use to evaluate non-MAF products.
The values given in parentheses are for information only. This standard does not purport to address all of the safety concerns, if any, associated with its use.
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B Specification for Electrodeposited Coatings of Cadmium. Link to Active This link will always route to the current Active version of the standard.